ISAM 7302配置说明

hans1025

首先将更新OSWP镜象文件用Write-CF写入CF卡。
登陆弹出对话后，输入c；用户名为：isadmin，初始密码：[email=i$@mad]i$@mad[/email]-，输完需要重新设置登陆密码，设置为：ans#150。
=============================================================
isadmin# configure system no single-public-ip （首先要关掉单IP策略）
isadmin# telnet shub （root admin123）
/# cd iss
/iss# external vlan 1000 （创建shub管理vlan）
/# cd /vlan5
/vlan5# shutdown
/vlan5# ip config 10.0.0.3 netmask 255.255.255.0 （配置shub的ip）
/vlan5# no shutdown
isadmin# configure interface shub port 0 port-type network （配置上联接口）
isadmin# configure interface shub port 0 admin-status up
isadmin# configure vlan shub id 1000 egress-port network:0
isadmin# configure system management host-ip-address manual:10.0.0.2/24 （配置nt的ip）
isadmin# configure system management default-route 10.0.0.1 （配置网关）
isadmin# configure system mgnt-vlan-id 1000 （创建nt管理vlan）
=============================================================
SNMP:
/acl# ip-mgmtvlan-filte 61.139.2.39
isadmin# configure ip shub vrf 0 route-dest 61.139.2.0/24 next-hop 10.0.0,1 vlan-id 1000
isadmin# configure system security snmp community public host-address 61.139.2.0/24 privilege read-write
isadmin# configure system security snmp shub community 3 name NETMAN privilege read-write ip-addr 61.139.2.3
=============================================================
配置板卡：
isadmin#configure equipment slot 1/1/1 planned-type aacu-c
isadmin>configure>equipment>applique>1/1/2 planned-type ecnc-a
iisadmin#configure equipment slot 1/1/4 planned-type eblt-j
=============================================================
配置profile：
isadmin# configure# xdsl service-profile 3 version 1 name 1m-fast min-bitrate-up
64 min-bitrate-down 64 plan-bitrate-up 512 plan-bitrate-down 1024 max-bitrate-up
512 max-bitrate-down 1024 max-delay-up 1 max-delay-down 1
isadmin# configure# xdsl service-profile 3 active
isadmin# configure xdsl spectrum-profile 3 name xdsl-default g992-5-a no dis-g992-1-a
isadmin# configure xdsl spectrum-profile 3 active
=============================================================
消除NT板告警：
isadmin# admin alarm clr-persist-loss
isadmin# configure equipment protection-group 1 admin-status lock
=============================================================
保存shub当前配置：
isadmin# admin software-mngt shub database save
=============================================================