通信人家园
标题: 朗讯9926基站调测 [查看完整版帖子] [打印本页]
时间: 2013-7-12 23:04
作者: mengfansen0721
标题: 朗讯9926基站调测
1 Offline RMT Setting将电脑IP设置为192.168.168.250，子网掩码默认，打开RMT 37.11 X20。
1.1 RMT Offline Connection将网线插入 “MC/OCM ETH”的网口上.
1.2 Check MT-BBU UTD（待鉴定）Click on Config -> Cell -> Unit Type Descriptor and check the following fields.
1.3 Check Boot Memory Parameters（调测之前把传输断开）1. 点击 Config->Cell->Boot Memory Parameters->BPSN/MAC Addresses getthe BPSN.
2. 刷入 TGCP and ILCP背板参数.
1.4 Select Generic上传9926版本3713DRGA，在boot中选择正确的版本点reset，active URC。（此时设备会重新启动）
1.5 Configure CTU(待版本上传完毕，激活版本，在进行CTU设置)Configure CTU, wait until “clocks are stable” in “clock status”.
1.6 Configure RRH （这里面的图片不准，例如三个扇区的话，第一个页面的左侧部分不选，右边的部分equipped点row的1、2、3，下一页应该是rrh1-1到rrh1-3，carries1到4然后Apply）
- Click Config->CBR/RRH Equipage
Check “Equipped” box for RRHs you want to configure.
- Click Next. Check carries for those RRHs.
- Click Apply then Cancel.
- Click Status->RF Head Status
RRH information is display as following window.
Some are Identified, some are Unidentified.
Check RRH configuration of those identified, and configure RRH unidentified.
Please notice that the RRH number must be consistent with MAC address.
- Click Apply .
- Confirm RRH status, should be all identified.
Sometimes 80W RRH is hard to identify. Please refer to Appendix A for 80W RRH sector id and unit id setting with command line..
最后的时候把GPS线下面的123搬下来。
时间: 2013-8-6 14:44
作者: zhang_s_z
:)
时间: 2014-12-22 14:13
作者: hehai2007
:)好东西啊
时间: 2018-1-26 19:13
作者: aszhfas
真是好东西啊，楼主能联系你吗，我有问题需要私下联系你，哪位大师能会这个测试也行，定有酬谢
| 通信人家园 (https://www.txrjy.com/) |
Powered by C114 |