通信人家园

标题: EPON 配置管理IP (中兴C220) [查看完整版帖子] [打印本页]

时间: 2011-1-31 10:53

作者: beisn 标题: EPON 配置管理IP (中兴C220)

Welcome to ZXAN product C220 of ZTE Corporation
************************************************

383-olt-c220-6#con t
Enter configuration commands, one per line.  End with CTRL/Z.
383-olt-c220-6(config)#vlan 3915
383-olt-c220-6(config-vlan)#ex
383-olt-c220-6(config)#show card
Rack Shelf Slot CfgType RealType Port  HardVer SoftVer       Status
-------------------------------------------------------------------------------
0 0    1 EPFC EPFC    4    V3.22 V1.1.3P4       INSERVICE
0 0    2 EPFC EPFC    4    V3.22 V1.1.3P4       INSERVICE
0 0    3 EPFC EPFC    4    V3.22 V1.1.3P4       INSERVICE
0 0    4 EPFC EPFC    4    V3.22 V1.1.3P4       INSERVICE
0 0    5 EPFC EPFC    4    V3.22 V1.1.3P4       INSERVICE
0 0    6 EPFC          4                            OFFLINE
0 0    7 GCSAS GCSAS 0    V0.4 V1.1.3P4       STANDBY
0 0    8 GCSAS GCSAS 0    V0.4 V1.1.3P4       INSERVICE
0 0    9 EPFC          4                            OFFLINE
0 0    10 EPFC          4                            OFFLINE
0 0    11 EPFC          4                            OFFLINE
0 0    12 EPFC          4                            OFFLINE
0 0    13 EIG             4                            OFFLINE
0 0    14 EIGM EIGM    4    V0.5 V1.1.3P4       INSERVICE
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#
383-olt-c220-6(config)#in
383-olt-c220-6(config)#interface ge
383-olt-c220-6(config)#interface gei_0/14/1
383-olt-c220-6(config-if)#sw
383-olt-c220-6(config-if)#switchport vlan 3915 ta
383-olt-c220-6(config-if)#switchport vlan 3915 tag
383-olt-c220-6(config-if)#ex
383-olt-c220-6(config)#in
383-olt-c220-6(config)#interface vlan 3915
383-olt-c220-6(config-if)#ip add
383-olt-c220-6(config-if)#ip address 172.16.101.136 255.255.255.0 ?
  A.B.C.D Broadcast address
  secondary  Secondary address
  <cr>
383-olt-c220-6(config-if)#ip address 172.16.101.136 255.255.255.0
383-olt-c220-6(config-if)#ex
383-olt-c220-6(config)#ex
383-olt-c220-6#write
Building configuration...
....[OK]
383-olt-c220-6#show run in
383-olt-c220-6#show run interface ep
383-olt-c220-6#show run interface epon-on
383-olt-c220-6#show run interface epon-onu_0/1/1:1
Building configuration...
  switchport mode trunk vport 1
  switchport vlan 1,100  tag vport 1
  authentication enable
  description $$兴隆城市花园ADEPON-1$$
  user-info no user's information
  bandwidth-profile 9806H vport 1
  encrypt direction downstream  enable  vport 1
  encrypt direction both disable vport 2
  autocfg disable
!
end
383-olt-c220-6#show run in
383-olt-c220-6#show run interface ep
383-olt-c220-6#show run interface epon-o
383-olt-c220-6#show in
383-olt-c220-6#show interface ep
383-olt-c220-6#show interface epon-ol
383-olt-c220-6#show run in
383-olt-c220-6#show run interface ep
383-olt-c220-6#show run interface epon-ol
383-olt-c220-6#show run interface epon-olt_0/1/1
Building configuration...
  no shutdown
  vlan-smart-qinq enable
  p2p mode group
  onu 1 type ZTE-9806 mac 0015.ebf9.9e7b ip-cfg static
  onu 2 type ZTE-F822 mac 0818.1a2f.43c2 ip-cfg static
!
end
383-olt-c220-6#in
% Unrecognized command
383-olt-c220-6#con t
Enter configuration commands, one per line.  End with CTRL/Z.
383-olt-c220-6(config)#in
383-olt-c220-6(config)#interface p
                              ^
% Invalid input detected at '^' marker.
383-olt-c220-6(config)#in
383-olt-c220-6(config)#interface ep
383-olt-c220-6(config)#interface epon-on
383-olt-c220-6(config)#interface epon-onu_0/1/1:1
383-olt-c220-6(config-if)#sw
383-olt-c220-6(config-if)#switchport vlan 3915 ta
383-olt-c220-6(config-if)#switchport vlan 3915 tag
383-olt-c220-6(config-if)#ex
383-olt-c220-6(config)#pon-onu
383-olt-c220-6(config)#pon-onu-mng ep
383-olt-c220-6(config)#pon-onu-mng epon-onu_0/1/1:1
383-olt-c220-6(epon-onu-mng)#mng
383-olt-c220-6(epon-onu-mng)#mng
383-olt-c220-6(epon-onu-mng)#m
383-olt-c220-6(epon-onu-mng)#?
  active                Configure active
  alarm                Enable alarm or not
  alarm-threshold       Configure alarm-threshold
  classification       Configure classification property
  config-pvid          Configure ZTE ONU pvid(only for ZTE ExtOAM Onu)
  config-vlan          Configure ZTE ONU vlan(only for ZTE ExtOAM Onu)
  dba                   Configure ONU DBA information
  end                   Exit to EXEC mode
  exit                   Exit the current configuration mode.
  fastleave             Configure ONU fast leave
  fec                   Configure FEC
  forbid-auto-dispatch Configure forbid-auto-dispatch
  holdover             Configure holdover
  interface             Configure ONU UNI information
  interface-loopdetect Configure interface loopdetect
  ip                   Configure ONU ACL
  isolation             Configure ONU port isolation
  llid-queue             Configure llid-queue
  mac                   MAC address management
  mgmt-ip                Configure IP properties
  mng-snmp             Configure mng-snmp
  multicast             Configure ONU multicast information
383-olt-c220-6(epon-onu-mng)#mg
383-olt-c220-6(epon-onu-mng)#mgmt-ip onu
383-olt-c220-6(epon-onu-mng)#mgmt-ip onu-ip 172.16.101.2 255.255.255.0  ?
  <0-7>  Priority.
383-olt-c220-6(epon-onu-mng)#$-ip 172.16.101.2 255.255.255.0  6 3915 ?
  gateway  Configure manage gateway
  mgm-ip Configure manage onu host IP
  svlan Configure svlan
383-olt-c220-6(epon-onu-mng)#$-ip 172.16.101.2 255.255.255.0  6 3915 mg
383-olt-c220-6(epon-onu-mng)#$gm-ip 172.0.0.0 255.0.0.0 172.16.101.1 ?
  status  Management status
  <cr>
383-olt-c220-6(epon-onu-mng)#$gm-ip 172.0.0.0 255.0.0.0 172.16.101.1 sta
383-olt-c220-6(epon-onu-mng)#$0.0.0 255.0.0.0 172.16.101.1 status en
383-olt-c220-6(epon-onu-mng)#$0.0.0 255.0.0.0 172.16.101.1 status enable
383-olt-c220-6(epon-onu-mng)#

时间: 2011-2-14 10:43

作者: avgzz 标题: 回复 1# 的帖子

沙发？呵呵第一个来学习~

通信人家园 (https://www.txrjy.com/)