Event 1a: A Primary CPICH enters the Reporting Range (FDD only).
Event 1b: A Primary CPICH leaves the Reporting Range (FDD only).
Event 1c: A Non-active Primary CPICH becomes better than an active Primary CPICH (FDD only).
Event 1d: Change of best cell (FDD only).
Event 1e: A Primary CPICH becomes better than an absolute threshold (FDD only).
Event 1f: A Primary CPICH becomes worse than an absolute threshold (FDD only).
Event 1g: Change of best cell in TDD.
Event 1h: Timeslot ISCP below a certain threshold (TDD only).
Event 1i: Timeslot ISCP above a certain threshold (TDD only).
Event 1j: A Non-active E-DCH but active DCH Primary CPICH becomes better than an active E-DCH Primary CPICH (FDD only).
Event 2a: Change of best frequency.
Event 2b: The estimated quality of the currently used frequency is below a certain threshold and the estimated quality of a non-used frequency is above a certain threshold.
Event 2c: The estimated quality of a non-used frequency is above a certain threshold
Event 2d: The estimated quality of the currently used frequency is below a certain threshold
Event 2e: The estimated quality of a non-used frequency is below a certain threshold
Event 2f: The estimated quality of the currently used frequency is above a certain threshold
Event 3a: The estimated quality of the currently used UTRAN frequency is below a certain threshold and the estimated quality of the other system is above a certain threshold.
Event 3b: The estimated quality of other system is below a certain threshold
Event 3c: The estimated quality of other system is above a certain threshold
Event 3d: Change of best cell in other system
event 4A: Transport Channel Traffic Volume becomes larger than an absolute threshold
event 4B: Transport Channel Traffic Volume becomes smaller than an absolute threshold
event 5A: A predefined number of bad CRCs is exceeded
event 6A: The UE Tx power becomes larger than an absolute threshold
event 6B: The UE Tx power becomes less than an absolute threshold
event 6C: The UE Tx power reaches its minimum value
event 6D: The UE Tx power reaches its maximum value
event 6E: The UE RSSI reaches the UE's dynamic receiver range
event 6F (FDD): The UE Rx-Tx time difference for a RL included in the active set becomes larger than an absolute threshold
event 6F (1.28 Mcps TDD): The time difference indicated by TADV becomes larger than an absolute threshold
event 6G:The UE Rx-Tx time difference for a RL included in the active set becomes less than an absolute threshold
Event 7a: The UE position changes more than an absolute threshold
Event 7b: SFN-SFN measurement changes more than an absolute threshold
Event 7c: GPS time and SFN time have drifted apart more than an absolute threshold
Event 7d: GANSS time and SFN time have drifted apart more than an absolute threshold