之前在RNC侧修改过参数，已知与邻区相关的命令脚本如下：
打开切换异系统3A开关
SET CORRMALGOSWITCH:HOSWITCH=EV_MEAS_HHO_SUPP-0&HO_INTRA_FREQ_HHO_SWITCH-0&HO_INTER_FREQ_HHO_SWITCH-0&BATON_HHO_SUPP-0&INTRA1IEV_HHO_SUPP-0&TIMING_ADVANCE_HHO_SUPP-0&QAUL_HO_SUPP-0&LOAD_HO_SUPP-0&HO_ACT_SET_QUAL_SWITCH-0&HO_SIGNAL_HO_SWITCH-0&HO_INTER_RAT_CS_OUT_SWITCH-0&HO_INTER_RAT_PS_OUT_SWITCH-0&CORRM_HO_2B_SUPP-0&PS_3G2G_CELLCHG_NACC_SWITCH-0&PS_3G2G_RELOCATION_SWITCH-0&SERVICE_HO_BASED_ON_RNC_SWITCH-0&HO_HCS_SPD_EST_SWITCH-0&HO_BLINDHO_SUPP-1;
打开总接力开关
SET CORRMALGOSWITCH: HOSWITCH=BATON_HHO_SUPP-1;